Ghost Remover from Mesh

Ghost remover from mesh

Ghost remover from mesh – two-component

GHOST CLEANER A LT.1

Cleaner for removing ghosts from screens, remnants of baked emulsion, and dried paint.

The cleaner is two-component and works only in combination of both (A+B):

› component A is a detergent that glazes the screen

› component B is a paste, which crystallizes in combination with the dry component A.

The combination of both components allows you to make old screens like new and you will print and print with them without interruption.

GHOST CLEANER PASTE B KG.1

Cleaner for removing ghosts from screens, baked-on emulsion residue, and dried ink.

The cleaner is a two-component product and works only as a combination of both (A+B):

› Component A is a detergent that creates a glaze on the screen

› Component B is a paste that crystallizes when combined with dry component A.

The combination of both components allows you to make old screens like new, enabling you to print continuously with them.

INSTRUCTIONS:

1. Using a sponge, apply component A to the dry screen.

2. Let it act at room temperature until it dries. The drying time depends on the mesh density.

3. Apply component B to dry component A using a squeegee.

4. Dry the screen at room temperature until crystallized, about 20/30 minutes (maximum 90 minutes).

5. After crystallization, thoroughly rinse the screen with a water jet.

TIPS:

› Always dry screens coated with components A or B in a horizontal position.

› Adhere to the approximate times (depending on the mesh – finer mesh requires less time, and vice versa); it is best to follow the crystallization process.

› Apply both components in a thin layer.

› Do not coat the mesh up to the frame, but rather leave a centimeter away where the tension is less.

WARNING:

The crystallization process is very intense and aggressive, so follow the manufacturer’s instructions and advice. In the worst case, the mesh may tear.